Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Draining the Reservoirs:
IMPORTANT! Unplug the dispenser before performing this procedure. Dispense hot water until temperature
drops to a safe level to avoid the risk of scalding.
1. Turn off the water supply, using manual shut-off valve at the rear of the dispenser.
2. Press both dispensing buttons until water stops flowing.
3. Place a container/bucket beneath the drain valve located at the rear of the dispenser (See Fig. 18).
4. Remove the drain cap and plug from the drain valve and let the remaining water flow into the container/bucket.
Replace the cap and plug.
Going Away on Vacation:
When not using the dispenser for long periods of time or when going on vacation, unplug the dispenser and drain the
reservoirs (see Draining the Reservoirs). Follow Initial Product Cleaning Procedures upon return and startup of the
dispenser.
s
pecIfIcatIons
GWD9500W-POU / GWD9500BLS-POU
Heating Temp (approx.):
Cooling Temp (approx.):
Output per hr:
Internal Tank:
Power Consumption:
Working Water Pressure:
t
roublesHootInG
Attention: Do not return this product to the store. For questions on operation, assembly or parts, please contact us at
www.greenwaywt.com or 1-866-253-0447.
PROBLEM
Water dispenser is leaking.
:
194°F / 90°C
35 - 52°F / 2°C - 11°C
Hot
1.2 gal / 4.6 L
0.2 gal / 0.6 L
1150 W
t
:
Ips
POSSIBLE CAUSE
Check all water line connections for
leaks.
Filter not properly secured and locked.
Drain cap and plug are not secure.
Cold tank reservoir is overfilled.
Cold
0.5 gal / 2.0 L
0.8 gal / 3.6 L
88 W
Up to 120psi
Repair water line connections and make sure
blue locking "c-clips" are installed on water
lines.
Secure Filter and lock.
Ensure drain plug is secure and tighten drain
cap.
See RE-SETTING WATER OVERFLOW
PROTECTION
10
SUGGESTED SOLUTION
Publicité
Table des Matières
