Care & Maintenance - Danby DWM055WDB Manuel Du Propriétaire

OPERATING INSTRUCTIONS
DELAY FUNCTION
The delay function can be used to set a program to
run at a later time.
• Press the Power button to turn the appliance on.
• Choose a program by pressing the Program
button.
• Press the Preset button repeatedly to select the
desired delay start time.
• Press the Start/Pause button to set the program.
For example, to delay the program for 5 hours,
press the Preset button until the display shows "05."
CHILD SAFETY FUNCTION
The child safety setting will sounds an alarm and
the wash water will drain if the lid is opened for
more than ten seconds during operation. It is
recommended to use this setting if there are small
children in the house.
• Select the desired wash program and press the
Start/Pause button to begin the program.
• Press and hold the Preset button and the
Program button at the same time to activate the
child safety function.
• The display will show "CL" to indicate that the
child safety function is active.
Note: Washing machines can present a child
entrapment hazard. Never leave a child unattended
with the appliance.
AUTOMATIC POWER OFF FUNCTION
If the washing machine is turned on and no
program is selected within 10 minutes, the
appliance will automatically power off to conserve
energy.
Once a wash program is complete, a buzzer will
sound six times to alert that the program is fi nished
and the appliance will automatically power off to
conserve energy.
CARE & MAINTENANCE
CLEANING
Before performing any cleaning or maintenance,
ensure that the water inlet hose has been
disconnected and that the power cord has been
unplugged.
Clean the outside of the appliance with a warm,
damp cloth. Avoid using detergents or chemicals as
this can damage or discolor the cabinet.
LINT FILTER
The lint fi lter should be cleaned after each program.
1. Remove the lint fi lter from the inner tub of the
appliance.
2. Open the lint fi lter and remove any lint that has
accumulated.
3. The lint fi lter can be rinsed under cold water to
remove any lint build up. Do not use detergents
or chemicals on the lint fi lter.
4. Ensure that the lint fi lter is replaced in the
appliance before beginning a new program.
WATER INLET
The water inlet may require periodic cleaning to
remove debris or hard water build up.
1. Ensure the water inlet hose has been
disconnected from the appliance.
2. Remove the fi lter screen from the inlet valve and
remove any debris or hard water build up. The
fi lter screen can be rinsed under cold water to
remove any build up.
3. Ensure that the fi lter screen is replaced in the
water inlet valve before reattached the water
inlet hose.
VINEGAR RINSE
A rinse of vinegar and water can be run through the
washing machine to remove any stains on the inner
tub or any lingering odors.
Place 1/2 cup of vinegar in the washing machine
and choose the highest water level. Allow the
appliance to run a full Wash & Rinse & Spin
program with no laundry to remove stains and
odors.
9