Program Selection; Function Instruction - Danby DWM055WDB Manuel Du Propriétaire

OPERATING INSTRUCTIONS

PROGRAM SELECTION

Use the instructions below to choose the desired
program.
Press the Function button repeatedly to manually
choose the wash program.
• Soak: For stained clothing.
• Wash only: For normally soiled clothing.
• Wash and rinse: To run a normal wash and
rinse program.
• Rinse and spin: For lightly soiled clothing.
• Spin only: For excessively wet clothing.
Press the Program button repeatedly to choose from
the preset programs.
• Heavy: For heavily soiled clothing.
• Jeans: For denim clothing.
• Normal: For normal laundry.
• Gentle: For delicate laundry.
Consult the table below for information on program
run times.
Note: Program times can vary based on the amount
of clothing in the washing machine and the water
pressure going into the inlet hose.
Function Rinse Cycles
Heavy 2
Jeans 2
Normal 1
Gentle 2
Total Cycle Time
57 minutes
44 minutes
32 minutes
43 minutes
8

FUNCTION INSTRUCTION

Prior to starting the washing machine, check the
following:
• The drain hose is in the correct position.
• There are no leaks in the inlet hose when the
faucet is turned on.
• The power cord is properly plugged into a three
prong grounded outlet.
• All coins and loose items have been removed
from clothing.
• The load includes a mix of large and small
items.
• Place clothing into the washing machine. Drop
items loosely into the tub. Do not pack items
tightly. Items must be able to move freely through
the wash water for best cleaning results.
• Add the desired amount of detergent.
• Press the Water Level button to choose the size
of wash load that will be completed.
• Press the Temperature Setting button to choose
the desired water temperature. Note that a
single hose hook up will not allow the use of
warm or hot water.
• Close the lid and press the Start/Pause button to
begin the desired program.
• A program can be paused once it is in
operation by pressing the Start/Pause button.
• If the load is unbalanced, and the safety switch
is triggered during spinning, the machine will
automatically refi ll with water to adjust the
balance.
• The appliance will not operate if the lid is open.
• When a program is fi nished, an alarm will
sound.
• To reduce the risk of electric shock and water
leaking, disconnect the water inlet hose and the
power cord when the appliance is not in use.