Danby DWM055WDB Manuel Du Propriétaire page 4

INSTALLATION INSTRUCTIONS
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior
to installation. Remove the shipping brace and
save it to prevent damage to washer components
whenever washer is moved or transported to
a new location. The shipping brace is a small
plastic brace that is adhered to the packing
Styrofoam. Ensure that you do not discard the
noise proof plate that is packaged on top of the
appliance.
• Wipe the outside of the appliance with a soft,
dry cloth and the inside with a lukewarm wet
cloth. Do not spray the appliance with water.
• Place the appliance on a level fl oor that is strong
enough to support it when it is fully loaded,
in a room that has convenient access to a
water supply and drain, has low moisture and
humidity and does not freeze in winter.
• Do not place the appliance on carpeted fl ooring
as this can block the lower ventilation openings.
• Keep the appliance away from heat sources and
out of direct sunlight. Excessive heat or sunlight
can deform or discolour the appliance.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• Allow 12.7 cm (5 inches) of space between the
back, sides and top of the appliance and all
adjacent walls.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
• Do not use excessively hot water in the
appliance, 50°C (122°F) or more. Plastic parts
and clothing may be deformed or damaged.
FEATURES
1. Water inlets (on the back of the appliance)
2. Lid
3. Control panel
4. Drain hose
5. Adjustable foot
3
LEVELING INSTRUCTIONS
It is important that the appliance is level to help
avoid unbalanced loads and excessive noise.
1. Turn the leveling foot counter-clockwise until
the top of the foot is touching the bottom of the
cabinet.
2. Slowly turn the leveling foot clockwise until the
appliance is level.
Note: This appliance includes two adjustable feet on
the front and two solid feet in the back.
Four rollers are provided to aid in moving the
appliance from place to place. To install the rollers,
place them in the holes on the bottom of the
appliance and push inwards until they click into
place.
3
1
2
4
5