Ryobi ONE+ P7181 Manuel D'utilisation page 7

This product contains no serviceable parts.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
CLEANING/REPLACING THE FILTER
See Figure 13, page 10.
 Remove the battery pack and the dust bowl.
 Remove the filter assembly by pulling it out of the dust
bowl.
NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER
MAINTENANCE
FRENCH AND SPANISH LANGUAGE SECTIONS.
 Shake or lightly brush any dust or dirt off the filter
assembly.
 Remove the prefilter by lightly pulling on one of the tabs
and lifting away from the assembly. The prefilter may be
rinsed if necessary.
 Empty the dust bowl; wash if necessary. Before reattach-
ing to the vacuum, make sure all pieces are completely
dry.
 Attach the prefilter to the filter by inserting the base of
the filter into the indent of the prefilter and snapping the
tabs into place.
NOTE: Carefully spread the tabs to help align and snap
them into place.
 Install the filter assembly into the dust bowl. Reattach
the dust bowl by aligning the slot on the bottom of dust
bowl with the tab on the bottom of motor housing, then
snap the two sections together.
When purchasing a replacement filter assembly, request
recommended part number 313282002.
7 — English