Télécharger Imprimer la page

Melitta One Therm Mode D'emploi page 14

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
First steps
3 First steps
3.1 Unpacking the appliance
Remove the packaging material and the adhe-
sive strips from the appliance. Please keep the
original packaging.
3.2 Setting up the appliance
Set up the appliance in a dry room.
ƒ
ƒ
Set up the appliance on a stable, flat and
dry surface. The surface may not be hot.
The appliance may not be placed in the
vicinity of sinks or the like.
ƒ
Route the power cable so it does not lie
over edges or cannot be damaged by hot
surfaces.
ƒ
Store the length of cable that you do not
need in the cable-winding facility in the
base of the appliance.
3.3 Connecting the appliance
Only connect the appliance to an easily acces-
sible, properly installed earthed mains socket.
After connecting, all lamps will illuminate
briefly one after the other.
Full isolation from the mains is achieved by
disconnecting the mains plug.
14
3.4 Removing the filter
To remove the filter, press the lever (13) and
pull the filter by the filter handle out of the
appliance.
The filter must click in audibly upon inserting.
Place the filter lid on the filter.
3.5 Removing the jug
Always hold the jug by the jug handle when
removing and inserting it.
Place the jug under the filter holder so that
the jug lid pushes the drip stop up slightly. This
opens the drip stop and the contents of the
filter can flow into the jug. The drip stop stops
coffee dripping when you remove the jug.
3.6 Removing the jug lid
To remove the lid, press and hold the side
catches (14) and lift the lid. Also press and
hold the side catches when you fit the lid
again.
To pour, press the lever (15) on the jug
handle.
13

Publicité

loading