Bluewater PRO Manuel Du Propriétaire page 5

EN
We recommend only approved technicians, distributors or
Bluewater service personnel perform installations, servicing and
repairs on the water purifier. If not performed adequately, this
can make it operate incorrectly, and lead to injury and damage
not covered by warranty.
Only use original replacement cartridges and parts
from Bluewater. For the spare parts catalogue,
see www.bluewatergroup.com. For purchase information,
contact your Bluewater dealer.
The inlet water must meet the requirements stated in
"REQUIREMENTS FOR INLET WATER to water purifier".
Installation must comply with applicable local plumbing codes
and regulations.
Connect the water purifier to an earthed/grounded electrical
supply. Use a plug that is easy to access after installation. Only
an approved electrician must do permanent wiring on the
system. Incorrect installation can lead to damage or make the
water purifier dangerous to use.
Do not use the power cord if there are visible signs of damage
on it. If the power cord is damaged, a qualified electrician must
replace it to prevent danger.
Do not use Pro without filters. This can cause damage to the
system. The filters can be removed when Pro is cleaned or put
into storage.
If the water purifier is disconnected from water and electricity for >5 days, store it as
described in Complete User manual "Put into storage".
Contact your Bluewater dealer for advice before moving the water purifier from one
place to another.
05
© Bluewater Group 2022