Publicité
Les langues disponibles
Les langues disponibles
4.1 Push rings (buttons)
► To execute an [esc], [●], [▼] or [▲] command, press the corresponding corner
of a push ring�
[esc]
Escape Return to the previous menu. Exit parameter setting without saving the
new value�
[●]
Enter
Enter menu mode (→ 8.2 Menu structure).
Selection of the parameter and acknowledgement of a parameter value�
[▼]
Down
Selection of a parameter� Setting a parameter value
(scrolling by holding down, incrementally by pressing repeatedly)�
[▲]
Up
When [▼] or [▲] is pressed during the operating mode for 1 second, the unit is
displayed. The displayed unit depends on the parameter C.uni (→ 8.5).
To ensure correct operation of the push rings (buttons), do not install or
place the device directly on a metal surface�
For the installation use the mounting clip (→ 5 Installation).
4.2 LEDs
LED
Colour
I
OUT1
yellow
Power
green
II
-
-
Error signals and diagnostics (→ 12 Fault correction)
4.3 Display
Colour
Description
Red/green
7-segment LED display, 4 digits, with colour change�
Error signals and diagnostics (→ 12 Fault correction)
In the operating mode the input current value is displayed� The scaling depends
on the parameter ScAL (→ 8.4.5).
Status
Description
on
Output 1 switched�
on
Voltage supply OK�
Device in operating mode�
off
Device in programming mode�
-
Without function
UK
43
Publicité
