Special Settings; Master/Slave-Operation - EuroLite RGB TL-150 DMX Mode D'emploi

Controlling:
After having addressed all RGB TL-150 DMX, you may now start operating these via your lighting controller.
Note:
After switching on, the RGB TL-150 DMX will automatically detect whether DMX 512 data is received or not.
If the data is received, then the yellow DMX LED blinks.
The DMX-LED is off:
- if there is no data received at the DMX-input.
- if the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the RGB TL-
150 DMX.
- if the controller is switched off or defective.
- if the cable or connector is defective or the signal wires are swap in the input connector.

Special settings

Via the Function-DIP-switches, you can adjust different modes and settings:

Master/Slave-Operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the device you can find an XLR-jack and an XLR-plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the OUT-jack with the IN-plug of the next device.
23/47 00025997.DOC, Version 1.2