Dorman 599-211XD Manuel D'installation

599-211XD
CLIMATE CONTROL
MODULE
A B
Power
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2024 No reproduction in whole or in part without prior written approval.
599-211XD_Tech-Note_v2
This climate control module will automatically undergo a configuration procedure after installation. Do
not use an external programmer or scan tool. Follow procedure below to complete configuration. If unit
fails to configure after two attempts, call Technical Support at 1-866-933-2911.
NOTE: Some piggyback and flash tuners do not display complete or partial VIN to ECM/BCM,
which will cause climate control module to configure incorrectly or not configure at all. To
install unit and configure, remove tuner or flash stock tune, then program module.
CONFIGURATION INSTRUCTIONS
STEP 1:
With new module installed, start vehicle to begin automatic configuration. Engine must be running for
entire process. Do not touch buttons or controls. Climate control module knobs and sliders do not need to
be in any particular position.
STEP 2:
Wait while system performs configuration sequence. While configuration is in process, LED(s) will
illuminate according to vehicle application. See Table A below.
NOTE: Configuration may take up to one minute.
STEP 3:
Configuration is complete when all button LEDs turn off.
IF CONFIGURATION IS UNSUCCESSFUL:
1. Remove power from climate control module by unplugging both connectors.
C
2. Wait 15 seconds. Reattach both connectors.
3. Repeat the procedure beginning with Configuration Instructions Step 1.
NOTE: If configuration is unsuccessful after two attempts, call Technical Support
at 866-933-2911.
Configuration
Number
01
02
03
04
05
06
07
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
Table A
Vehicle Applications
2003-2004 Cadillac Escalade, Chevrolet Avalanche,
Suburban, Tahoe, GMC Yukon; 2003-2004 Chevrolet
Silverado, GMC Sierra
2005-2006 Cadillac Escalade, Chevrolet Avalanche,
Suburban, Tahoe, GMC Yukon; 2005-2007 Chevrolet
Silverado, GMC Sierra
2003-2007 Hummer H2
2004 Buick Rainier; 2003-2004 Chevrolet Trailblazer,
GMC Envoy, Oldsmobile Bravada
2005-2006 Buick Rainier; 2005-2006 Chevrolet
Trailblazer, GMC Envoy
2002 Chevrolet Trailblazer, GMC Envoy; 2002
Oldsmobile Bravada
2007 Buick Rainier; 2007-2009 Chevrolet Trailblazer,
GMC Envoy
PAGE 1 OF 3
LED Active
During Configuration
Rear Defrost
(C)
Front Defrost
(B)
Front and Rear Defrost
(B & C)
Recirculation
(A)
Recirculation and Rear Defrost
(A & C)
Recirculation and Front Defrost
(A & B)
Recirculation, Front and Rear
Defrost (A, B, & C)