Dorman 599-040 Manuel D'instructions

INSTRUCTIONS
CLIMATE
CONTROL
MODULE REPAIR
KIT
599-040
A
B
D
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2025 No reproduction in whole or in part without prior written approval.
599-040_Instructions
KIT CONTENTS
A Flexible printed circuit (FPC) ribbon cable
B Small board with knob
C Replacement bulbs (Qty: 5)
D Plastic window
INSTRUCTIONS
STEP 1:
Remove climate control module from
vehicle.
STEP 2:
C
On bench, remove temperature adjustment
knob, screw and washer.
STEP 3:
Flip over climate control module and pry off
plastic window from back of housing.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 4:
Disconnect FPC ribbon cable from back
housing board.
NOTE: Ribbon connectors have
locking mechanisms that must
be unlocked before removing
ribbon cables.
STEP 5:
Remove screws on back of climate control
module. Remove back housing from climate
control module.
STEP 6:
Disconnect other end of FPC ribbon cable
(that connects to back housing) from
main board.
PAGE 1 OF 2