Publicité
Les langues disponibles
Les langues disponibles
OPERATION INSTRUCTION
BATTERY
IMPORTANT! The battery pack is not charged when it is purchased. Before using the blower for
the first time, place the battery pack in the battery charger and charge. Make sure to read all safety
precautions, and follow the instructions in the Battery Charger section.
To Remove (See Figure 4.)
1. Press and hold the battery release button with firm grip.
2. Grasp the trigger handle firmly. Pull the battery pack out of the handle.
NOTE: The battery pack fits into the handle snugly in order to prevent accidental dislodging. It may
require a strong pull to remove it.
To Install (See Figure 4.)
1. Align the tongue of the battery pack with the cavity in the handle housing.
2. Insert the battery into the battery opening until the battery release button locks into place.
3. Grasp the trigger handle firmly.
4. Push the battery pack into the handle until both sides lock. The latch button will click when locked
into place.
5. Do not use force when inserting the battery pack. It should slide into place and click.
W A R N I N G
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or fire:
• Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
• Verify that the switch is in the OFF position before inserting or removing the battery pack.
• Verify that the battery pack is removed and the switch is in the OFF position before inspecting,
adjusting, or performing maintenance on any part of the blower.
• Read, understand, and follow the instructions contained in the section entitled Charging
Procedure.
Trigger Handle
Battery Release Button
12
FIG.4
Publicité
