Publicité
Les langues disponibles
Les langues disponibles
5.9
Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Switching on
6
The on / off switch with switch-on interlock gives you full control of the switch function and avoids
unintentional starting.
1. Push the switch-on interlock forward.
▶ The on/off switch is unlocked.
2. Press the on/off switch as far as it will go.
▶ The power tool's motor runs at no-load speed.
6.2
Holding the product correctly
1. Use clamps or some other practical means to secure the workpiece and keep it in a stable position.
2. Use both hands to hold the product firmly when working.
▶ The product can become unstable if you attempt to hold it with only one hand or pressed against a
part of the body and this can result in loss of control.
6.3
Operation
1. Hold the product firmly without the tool bit contacting the working surface.
2. Switch on. → page 10
3. Guide the accessory tool straight into the material in which the cut-out is to be made, until the depth
gauge is in contact with the working surface.
4. Applying steady pressure, advance the accessory tool.
6.4
Switching off
▶ Release the on/off switch.
▶ The switch-on interlock jumps automatically into the locked position.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
10
English
7
2264442
*2264442*
Publicité
