Publicité
Mode d'emploi Systèmes de sécurité
MGB-L1...-AR.-... / MGB-L2...-AR.-... et MGB-L1...-AP.-... / MGB-L2...-AP.-...
14.1.
Homologations radio (pour les appareils avec FCC ID et IC sur la plaque signalétique)
Product description: Safety Switch
FCC ID: 2AJ58-09
IC:
22052-09
FCC/IC-Requirements
This device complies with part 15 of the FCC Rules and with Industry Canada's licence-exempt RSSs. Operation is subject
to the following two conditions:
1) This device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploi-
tation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
This device complies with the Nerve Stimulation Exposure Limits (ISED SPR-002) for direct touch operations.
Cet appareil est conforme aux limites d'exposition relatives à la stimulation des nerfs (ISED CNR-102) pour les opérations
tactiles directes.
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identifier:
MGB-L0-AR Series
MGB-L1-AR Series
MGB-L2-AR Series
MGB-L0-AP Series
MGB-L1-AP Series
MGB-L2-AP Series
Responsible Party – U.S. Contact Information
EUCHNER USA Inc.
6723 Lyons Street
East Syracuse, NY 13057
+1 315 701-0315
+1 315 701-0319
info(at)euchner-usa.com
http://www.euchner-usa.com
38
(trad. mode d'emploi d'origine) 2119167-07-09/23
Publicité
