Novoferm N-563 Mode D'emploi page 72

7.1 Restoring the factory settings
1. Press the OPEN (B) and CLOSE (C) buttons at the same time.
B
C
Fig. 16: Factory settings
2. Press both buttons for approximately 3 seconds while pulling out the mains
plug from the mains socket and while reinserting the mains plug again.
7.2 Cycle counter
The cycle counter stores the number of OPEN/CLOSE actions powered by the
drive. To read the meter, hold the button (C) at the drive head for 3 seconds until
you see a figure.
The digital display shows the numbers starting from the highest to the lowest
decimal place consecutively. At the end, a horizontal line appears on the display,
for example: 3456 movements, 3 4 5 6 –.
70 - EN