Denon DJ LC6000 PRIME Guide D'utilisation page 8

Looping & Beat-Jumping
To create and activate an auto loop, press the Auto Loop knob.
To set the auto loop length, turn the Auto Loop knob to select the number of beats: 1/32, 1/16, 1/8, 1/4, 1/2, 1,
2, 4, 8, 16, 32, or 64.
To create and activate a manual loop, press Loop In to set the start point, and then press Loop Out to set the
end point. The loop will be activated immediately, and the loop will be indicated as a shaded area in the
waveform and track overview.
To deactivate a loop, press the Auto Loop knob.
To move the loop, press and hold Shift and turn the Auto Loop knob while the loop is activated.
To double or halve the length of a loop, turn the Auto Loop knob while the loop is activated.
To manually edit the beginning or end of a loop, press Loop In or Loop Out respectively, then move the platter
left or right to shorten or extend the loop region. Commit the edit by pressing Loop In or Loop Out again.
To beat-jump through a track, press one of the Beat Jump buttons. Each press will skip through the track by the
length of an auto loop, which you can set by turning the Auto Loop knob.
Syncing & Pitch Adjustment
To activate sync, press Sync on the unit that you want to control the BPM, which becomes the "master." After
Sync is activated on that unit, press Sync on any additional units. The tempo of each unit will immediately
synchronize to match the tempo of the master unit.
The Sync state icon in the display of your connected Denon DJ media player will indicate the current status:
•
Sync Off: Sync is deactivated.
•
Tempo Sync: Only the tempo is synced (the BPM will match that of the master unit).
•
Beat Sync: The tempo will be synced, and the track will be automatically beat-matched with the track on
the master unit.
To deactivate sync on an LC6000 PRIME unit, press Shift+Sync.
To set a different LC6000 PRIME unit as the master, press Master. All connected LC6000 PRIME units or
compatible Denon DJ media players with Sync activated will use the tempo of this unit.
To adjust the track's pitch, move the pitch fader. You can do this only when the deck is not synced.
Important: If Sync is activated, moving the pitch fader on the "master" LC6000 PRIME unit will change the
speed of all synced units, while moving the pitch fader on other units will do nothing.
To adjust the track's pitch momentarily, press and hold one of the Pitch Bend –/+ buttons.
To adjust the range of the pitch fader, press and hold Shift and press one of the Pitch Bend –/+ buttons to
select +4%, 8%, 10%, 20%, 50%, or 100%.
To reset the track's pitch to 0%, press Shift+Key Lock/Pitch Reset. The track's pitch will return to its original
pitch (0%) regardless of the position of the pitch fader.
8