Denon DJ LC6000 PRIME Guide D'utilisation page 7

Operation
Note: These instructions are primarily for use with compatible media players. Some controls or functions
listed may not work with all supported software. For more details on software mappings, visit
or your software's website.
Performing
Loading & Removing Tracks
While viewing any track list:
To load a track to the layer, press the Select/Zoom knob.
To perform instant doubles (load the same track to both layers on the deck), double-press the
Select/Zoom knob while the track is highlighted.
To add a track to the Prepare list, press and hold Shift and press the Select/Zoom knob.
Playback & Cueing
To play or pause a track, press Play/Pause (/).
To scratch a track, press Vinyl so it is lit brightly and then move the platter.
To set the initial cue point, press Shift+Cue at the desired location during playback.
To return to the initial cue point and stop, press Cue. The button will flash while the unit is paused at the cue point.
To return to the initial cue point and keep playing, press Shift+Play/Pause (/).
To reverse playback, press Shift+Censor/Reverse. The button will flash while playback is reversed.
To return to normal playback, press Censor/Reverse.
To censor playback, press and hold Censor.
To return to normal playback, release Censor. Normal playback will resume from where it would have been if
you had never engaged the Censor feature (i.e., as if the track had been playing forward the whole time).
To skip to the previous or next track, press one of the Track Skip / buttons.
To return to the beginning of a track, press Track Skip  in the middle of a paused track.
To scan quickly through the track, press and hold Shift and then press one of the Beat Jump buttons.
To enable or disable Slip Mode, press Slip. In Slip Mode, you can jump to cue points, use the platters, or pause the
track while the track's timeline continues (the lower half of the waveform in the touchscreen will continue moving
forward). When you stop whatever action you are performing, the track will resume normal playback from where it
would have been if you had never done anything (i.e., as if the track had been playing forward the whole time).
To jump to a specific location in the track, place your finger along the length of the Needle Drop strip, which
represents the length of the track.
Note: Make sure that Needle Lock is disabled on your connected Denon DJ media player in order to use the
Needle Drop strip.
To zoom in and out of the waveform, turn the Select/Zoom knob while in Performance View on your connected
Denon DJ media player.
denondj.com
7