Publicité
Les langues disponibles
Les langues disponibles
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the effect to the mains, the TMH-250 EHJ starts running. During the Reset, the motors
are trimmed and the device is ready for use afterwards.
Turn the focus-screw next to the objective-lens for adjusting the focus in order to obtain a sharp projection.
Display and function buttons
Press the Function Button and select from the functions F1 – F4.
F1 - Pan Reverse
With this function you can reverse the Pan-movement.
• Press the Function button and select „F2".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
F2 - Tilt Reverse
With this function you can reverse the Tilt-movement.
• Press the Function button and select „F2".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
F3 - 16 Bit operation
With this function you can reduce the projector-movement to 16 bit.
• Press the Function button and select „F3".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
F4 - Demo operation
In the Stand Alone mode, the TMH-250 EHJ can be used without controller. Disconnect the TMH-250 EHJ
from the controller and call up the internal program (F4).
• Press the Function button and select „F4".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
29/63
51786500_V_1_1.DOC
Publicité
