emerio FN-111537.1 Mode D'emploi page 5

PARTS DESCRIPTION
1. Front fan guard
2. Fan blade
3. Base
4. Speed buttons
ASSEMBLING INSTRUCTION
1. Unscrew the grill retaining ring from the motor shaft.
2. Put the rear fan guard on the motor shaft and screw together with the grille retaining ring.
3. Put the fan blade on the motor shaft.
4. Put on the front fan guard and then close the clips and using the appropriate screw to secure the grille
together.
OPERATING INSTRUCTIONS
1. Plug the power cord into a suitable socket.
2. Oscillation: to make the fan head oscillate, push down the oscillation knob. To stop the fan head from
oscillating, pull-up the oscillation knob.
3. The fan is switched on using the push buttons on the base, i.e. 0: Off, 1 = Low speed, 2 = High speed
CAUTION: Press only one of the speed control button at a time. Permanent damage to the switch housing may
result if two or more of the buttons are pressed simultaneously.
CLEANING
1. Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains
cable from the socket.
2. Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it
down with a damp cloth and then dry it carefully. Always take out the mains plug first.
3. Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it
occasionally using a dry brush or vacuum cleaner.
TECHNICAL DATA
Supply voltage: 220-240V ~ 50Hz
Power consumption: 20W
Eco design requirements
Product information requirements
Maximum fan flow rate (F)
Fan power input (P)
Service value (SV)
Measurement standard for service value
Standby power consumption (P
Fan sound power level (L
- 4 -
)
SB
)
WA
13.50 m³ /min
18.12 W
0.75 (m³ /min)/W
(EU) No 206/2012
IEC 60879:1986
EN 50564:2011
EN 60704-2-7:1998
EN 60704-1: 2010
0.00 W
52.70 dB(A)
FN-111537.1