Publicité
Les langues disponibles
Les langues disponibles
OPERATING THE APPLIANCE
Open door alarm
An alarm signal sounds when a door is open for too long. The alarm key flashes in the display.
The lighting will begin to flash after a few minutes.
Stopping the alarm
1. Close the door.
The alarm will stop sounding.
▷
When the door is still open after 10 minutes then the appliance will switch to safe mode.
The LED lighting goes off. Error code E9 will be shown in the display (see the chapter
'Faults').
If you only switch off the alarm by touching any key, the alarm will switch on again after
some time because the door is still open.
High temperature alarm
A signal will sound when the temperature in the appliance is too high. The alarm key and the
set temperature shown in the display will flash. A high temperature can be caused for several
reasons:
•
The door has been opened for too long or too frequently.
•
The door does not seal properly.
•
Too much fresh food has been put in at the same time.
Every time the appliance is switched on again, it takes a while until the correct
temperature is reached. For this reason, the alarm is disabled for the first 24 hours after
the appliance is switched on to prevent the unnecessary activation of the alarm.
Stopping the alarm
1. Touch any key to stop the alarm.
▷
The alarm will stop sounding.
▷
The alarm key and the set temperature shown in the display continue to flash while the
temperature is still too high.
When the alarm is not stopped manually and the temperature remains too high, the signal
will sound for the first minutes of every half hour and when the door is opened.
EN 26
Publicité
