Store The Machine; Troubleshooting; Technical Data - GreenWorks Pro LMC415 Manuel D'utilisation

EN
8. Install the new blade. Make sure that the arrows
engage the holes in the blade.
9. Put in the mounting screw and tighten it.
8.3

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the motor is not hot when you put the
machine into storage.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
You may lower the handle(s) before you put the
machine into the storage.
1. Fully loosen the handle fasteners on the sides of the
handle(s).
2. Fold away the handle(s).
3. Do not pinch or trap the cables.
9

TROUBLESHOOTING

Problem
The handle is
not in position.
The machine
does not start.
The machine
cuts grass un-
evenly.
The machine
does not mulch
correctly.
Possible cause Solution
The bolts are not Adjust the height
engaged correct- of the handle
ly. and make sure
that the knobs
and bolts are
aligned correctly.
The battery ca- Charge the bat-
pacity is low. tery pack.
The bail switch is Replace the bail
defective. switch.
The battery key Put in the battery
is not put in. key.
The lawn is Examine the
rough. mowing area.
The blade height Move the wheels
is not set cor- to a higher posi-
rectly. tion.
Wet grass clip- Wait until the
pings attach to grass dries be-
the deck. fore mowing.
The mulch plug Install the mulch
is missing. plug.
English
Problem
The machine is
hard to push.
There is a high
vibration in the
machine.
The machine
stops during
mowing.
* If you cannot find the solution to these problems, go to
the service center.
10

TECHNICAL DATA

Voltage 60 V
No load speed 3500 RPM
Deck size 17"
Height adjust- 1 - 3 1/8" (2.5 - 8 cm)
ments
Functions 2-in-1 Mulch & Rear Bag
12
Possible cause Solution
The grass is too Increase the
tall, or the blade blade height.
height is too low.
The grass catch- Empty the grass
er and the blade clippings from
drags in thick the grass catch-
grass. er.
The blade is un- Replace the
balanced and blade.
worn.
The motor shaft 1. Stop the mo-
is bent. tor.
2. Remove the
safety key
and battery
pack.
3. Disconnect
the power
source.
4. Inspect for
damage.
5. Repair the
machine be-
fore you start
it again.
The blade height Increase the
is too low. blade height.
The battery pack Charge the bat-
is out of power. tery pack.
The grass clip- Remove the bat-
pings attach to tery pack and
the deck or the check the deck.
blade.
Operation tem- Cool the ma-
perature of the chine.
machine is too
high.