Dimplex Ignite 60 Manuel Du Propriétaire page 9

Fireplace Installation
Figure 3
Glass Openings
Partially Reflective Glass
To prevent electrical shock this
unit is an electrical appliance
that is NOT watertight and must
be installed as to prevent water
from entering unit. This must be
installed away from showers, tubs,
etc. Never locate fireplace where
it may fall into a bathtub or other
water container.
Final Assembly
1. Locate and
12 screws securing the partially
reflective
the unit, along the top of the
opening, and set bracket and
screws aside.
2. Remove the provided suction
cup from the inside cavity of
the unit (only for XLF60, XLF74
and XLF100 units).
remove
glass bracket
Retaining Bracket
Media Tray
3. Before installation ensure that
the front glass and the partially
reflective
Particles can be removed by
dusting lightly with a clean dry
cloth. To remove fingerprints
or other marks, the glass
can be cleaned with a damp
cloth. Ensure that the glass
has completely dried before
installation.
4. Carefully secure the suction
the
cup to the partially reflective
glass, reflective side out, and
to
place into the openings on
either side of the unit.
5. Tip the glass into the unit and
using the removed screws
secure the glass into the unit
with
(Figure 3). Remove the suction
cup.
glass are
the provided
clean.
bracket
9