Automatic Operation; Cooling / Heating / "Fan Only" Operation - Saunier Duval SDH 10-020 MCNHWI Notice D'utilisation

7- INDICATORS ON THE DISPLAY OF REMOTE CONTROL

7.2- AUTOMATIC OPERATION

5 6
CLOCK SET TE
FAN SPEED
▴▴
5 6
In the AUTO mode the system will automatically select
cooling, heating (if equipped), or "fan only" operation,
depending on temperature setting on the remote control
and current indoor temperature.
Once the AUTO mode is selected, the operating conditions
are saved in a memory inside the unit's microcomputer.
If the air conditioner is switched ON again by simply
pushing the ON/OFF button at the remote control, the unit
will operate under the same conditions as before.
Start
Ensure the unit is plugged and electric power is available.
The operation indicator on the display panel of the indoor
unit starts flashing.
1. Press MODE button until AUTO mode is selected.
. Use TEMP/TIME button to select the desired tempera-
ture. In general the selected temperature is 1°C
– 8°C.
. If the unit is switched OFF, press the ON/OFF button to
start the air conditioner.
Stop
1. Press the ON/OFF button again to stop the air condi-
tioner operation.
If the AUTO mode is uncomfortable, the desired conditions
can be selected manually.
In the AUTO mode it is not necessary to set any fan speed.
The fan speed is controlled automatically.
11 11