Drinkwell PWW17-16930 Guide De Démarrage Rapide page 5

Assemble Pet Fountain
Note: Rinse all of the fountain components (except
for the adaptor) with warm water before using the
pet fountain. This will remove any residue from the
manufacturing process.
1. Take the pump apart by first removing the blue
faceplate. Use your finger to pull up on the
small tab.
2. Remove the teardrop shaped stator by pulling
up on the small lip.
3. Use a fingernail to pull out the impeller, which
is held in place magnetically. Clean the pump
parts with warm water and soap. Reassemble
the pump by first inserting the impeller. Then,
replace the stator and faceplate.
4. Place the pump into the foam filter with the cord
running above it.
1
2
3
4
petsafe.com 5