Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS FOR THE USER
CLEANING
Before any operation, disconnect the
appliance from the electric grid. Don't use
a steam cleaner for the cleaning the hob.
It is advisable to clean the appliance
when it is cold.
Enamelled parts
The enamelled parts must be washed with a
sponge and soapy water or with a light detergent.
Do not use abrasive or corrosive products.
Do not leave substances, such as lemon or tomato
juice, salt water, vinegar, coffee and milk on the
enamelled surfaces for a long time.
Stainless steel parts
Stainless steel can be stained if it remains in
contact with highly calcareous water or aggressive
detergents for an extended period of time.
The stainless steel parts should also be cleaned
INSTRUCTIONS FOR THE INSTALLER
IMPORTANT NOTICE:
THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED
PERSONNEL EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN
FORCE.
THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES
TO PEOPLE, ANIMALS OR THINGS, RESULTING FROM THE FAILURE TO
COMPLY WITH SUCH PROVISIONS.
INSTALLATION
The installation must be performed in conformi-
ty with current regulations.
Installing the top
The appliance is designed to be embedded into
heat-resistant pieces of furniture.
The walls of the pieces of furniture must resist a
temperature of 75°C besides the room one.
The equipment must not be installed near
inflammable materials, such as curtains, cloths,etc.
Make a hole in the top of the piece of furniture,
with the dimensions indicated in fig. 3, keeping
a distance of at least 50 mm between the rear
edge of the installed device and 100 mm from the
adjacent side walls .
with soapy water and then dried with a soft cloth.
Burners and racks
These parts can be removed to make cleaning
easier.
The burners must be washed with a sponge and
soapy water or with a light detergent, wiped well
and placed in their housing perfectly.
Make sure that the flame-dividing ducts are not
clogged.
Check that the feeler of the safety valve and the
start-up electrode are always perfectly cleaned, so
as to ensure an optimum operation.
Gas taps
The possible lubrication of the taps must be
carried out by specialized personnel, exclusively.
In case of hardening or malfunctions in the gas
taps, apply to the Customer Service.
MODEL
BGGN60BE
BGGN70BE
Any possible wall unit over the cook-top must be
placed at a distance of at least 760 mm from the
top.
It is advisable to isolate the appliance from the
piece of furniture below with a separator, leaving a
depression space of at least 10 mm (fig. 4).
28
L (mm)
D (mm)
560
480
560
480
Publicité
