Publicité
Les langues disponibles
Les langues disponibles
2. Check the standby status after plugging into an electrical outlet
The LINK LED indicator (blue LED) on the Wireless Receiver Module blinks. If the LED does not blink,
press the ID SET button on the back of the Wireless Receiver Module with a pen tip for 5~6 seconds
until the LINK LED indicator blinks (in Blue).
Attach the Toroidal Ferrite Core to the Power Cord of the Soundbar
Bottom of the Soundbar
DIGITAL AUDIO IN
(OPTICAL)
SERVICE
DIGITAL AUDIO IN
(OPTICAL)
DC 19V
SERVICE
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
ID SET
POWER
POWER
SERVICE
DC 19V
NETWORK
ID SET
DIGITAL AUDIO IN
(OPTICAL)
SERVICE
DC 19V
NETWORK
ID SET
DIGITAL AUDIO IN
(OPTICAL)
SERVICE
DC 19V
DIGITAL AUDIO IN
NETWORK
ID SET
(OPTICAL)
HDMI IN
SERVICE
HDMI OUT
(TV-ARC)
DC 19V
5 Sec
ID SET
Attach the Toroidal ferrite core to the power cord
of the Soundbar to help prevent RF interference
from radio signals.
1. Pull the fixing tab of the Toroidal ferrite core
to open it.
2. Make two loops in the Soundbar's power
cord.
3. Attach the Toroidal ferrite core to the
Soundbar's power cord as shown in the
figure on the left, and then close it by
HDMI
HDMI TO TV
(eARC/ARC)
pressing it until it clicks.
• Ensure that the ferrite core is attached as
close as possible to the power jack of the
Soundbar.
HDMI
HDMI TO TV
(eARC/ARC)
ENG - 21
STANDBY
LINK
STANDBY
LINK
Blue blinking
Publicité
