HEIDENHAIN ND 100 QUADRA-CHEK Guide D'installation page 4

ND 100 QuaDra-Chek
Installation Instructions
Complete Operating Instructions available at www.heidenhain.de
4. Specifications
The ND 100 QUADRA-CHEK is an advanced digital readout system for performing 2 and
3 axis measurements at very high levels of precision and accuracy. This unit is designed
for indoor use only. The ND 100 components shall only be installed as described in these
instructions. Mounting, installation and maintenance are to be performed by qualifi ed
personnel only.
Power input:
replaceable fuse:
environmental conditions
Operating temperature:
Storage temperature:
Relative humidity:
Altitude:
Protection:
Overvoltage category:
Pollution degree:
Mass:
5. Mounting
Do not mount in a position that makes it diffi cult to access the power switch or
power cable.
The ND 100 QUADRA-CHEK may be mounted by attaching the product to a mounting arm
(ID 382893-01), a tilting base (ID 625491-01) or a mounting frame (ID 647702-01). Refer to
the Accessories section for mounting diagrams.
Notice
Refer to the documentation provided with the accessories for mounting
instructions.
6. Installation
The safety of any system incorporating the use of this product is the
responsibility of the assembler or installer of the system.
Interfaces
rear
Power switch
1
Power connector
2
replaceable fuse holder
3
uSB (type B) interface: for
4
PC communication
encoder inputs: X1, X2, X3 axis for
5
linear and rotary  TTL interface
encoders. The number of axes varies
by product.
earth (ground) terminal
6
see warning below
4
A C 100 V ... 240 V (-15 % ... +10 %)
50 Hz ... 60 Hz (± 2 %)
(max. 54 W)
T 500 mA / 250 V, 5 mm x 20 mm
0 °C ... 45 °C
-20 °C ... 70 °C
 80 % RH
 2000 m
IP40, front IP54
I I, equipment intended to be supplied from the building
wiring
2
2.6 kg
Power cord
Line voltage (brown)
L:
N: Neutral (blue)
Protective conductor (ground)
terminal(green/yellow)
3-conductor (grounded)
Min. cable cross section: 0.75 mm
Max. cable length: 3 m
2
Power cord