General Radio Compliance - Welch Allyn RPM-Scale100 Mode D'emploi

A-12 Appendices
Item
Auto-OFF
Degree of protection
Protection against ingress of
water
Software Version

General radio compliance

Item
Bluetooth Module No.
RF Frequency Range
Output Power
Supply Voltage
Antenna Gain
Transmitting Distance
Federal Communication Commission (FCC) Interference Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions.
•This device may not cause harmful interference.
•This device must accept any interference received, including interference that may
cause undesired operation.
This equipment (FCC ID: OU9BS-1507) has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures.
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Consult the dealer or an experienced radio/TV technician for help.
Specification
About 15 seconds when showing 0.0
About 15 seconds after the weight data is locked
Type BF applied part
IP22
Version 1.0
Specification
AW51822
2402 MHz to 2480 MHz
4.0 dBm
1.8-3.6 V
0dBi
10 meters, (30 feet)
Welch Allyn Remote Monitoring Scale RPM-Scale100