Select The Measurement Unit; Obtain Measurement; Stop A Measurement; Maintain The Scale - Welch Allyn RPM-Scale100 Mode D'emploi

A-8 Use the scale
2. Press and hold the Unit button on the bottom of the scale for 2 seconds.
The Bluetooth pairing sequence is activated. The dotted line surrounding the
Bluetooth symbol flashes while discovering the weight scale.
If successful, a steady
LCD screen. If unsuccessful, the

Select the measurement unit

The default measurement unit is pound (lb).
Press the Unit button on the bottom of the scale to change from pound (lb) to
kilogram (kg).

Obtain measurement

With the original SENSE ON patent technology, the scale automatically powers on when
you step on the platform in your bare feet.
1. Step on the platform in your bare feet.
The scale automatically powers on and begins the measurement.
2. Stand still and keep full contact with the scale until the LCD stops blinking and
displays the weight.

Stop a measurement

You can stop a measurement before it is complete.
Step off the platform.
The scale returns to a ready / zero state.
After approximately 2 seconds, the scale powers down automatically.

Maintain the scale

Clean on a routine basis according to facility protocols and standards or local regulations.
Disinfect according to facility protocols and standards or local regulations.
The following agents are compatible with the device:
• CaviWipes or Sani-Cloth Plus
• 70 percent isopropyl alcohol
• 10 percent chlorine bleach/90 percent water solution
symbol surrounded by a dotted line appears on the scale's
Warning Patient injury risk. Keep the device clean. Patient contact with
contaminated equipment can spread infection. Clean the device after each
patient use.
Welch Allyn Remote Monitoring Scale RPM-Scale100
appears.