Télécharger Imprimer la page

Audio-Technica AT-LP60 Mode D'emploi page 8

Publicité

Les langues disponibles

Les langues disponibles

Tips For Better Performance
Tips For Better Performance
When opening or closing the turntable cover, handle it gently,
moving it either at the center or equally from both sides.
Do not touch the stylus tip with your fingers; avoid bumping
the stylus on the turntable mat or a record's edge.
Clean the stylus tip frequently, using a soft brush with a
back-to-front motion only.
If you use a stylus cleaning fluid, use it very sparingly.
Wipe the dust cover and turntable housing gently with a soft
cloth. Use only a small amount of mild detergent solution to
clean the turntable and dust cover.
Never apply harsh chemicals or solvents to any part of the
turntable system.
Prior to moving the turntable, always unplug it from the AC
outlet and fasten the tone arm on the tone arm rest with the
vinyl twist-tie.
Specifications
Type
Platter
Motor
Speeds
Wow and flutter
Signal-to-noise ratio
Cartridge
Output level
Pre-amp "PHONO"
Pre-amp "LINE"
Phono pre-amp gain
Power
Dimensions
Net weight
Furnished accessories
Replacement stylus
8
Belt drive turntable, fully automatic
Aluminum
DC servo-controlled
33
/
RPM, 45 RPM
1
3
Less than 0.25% (WTD) @ 3 kHz (JIS)
>50 dB (DIN-B)
Integral Dual Magnet
stereo cartridge with diamond stylus
2.5 mV nominal at 1 kHz, 5 cm/sec
150 mV nominal at 1 kHz, 5 cm/sec
36 dB nominal, RIAA equalized
120V AC, 60 Hz, 3W
360.0 mm (14.17") W x 97.5 mm (3.84") H x 356.0 mm (14.02") D
2.98 kg (6.6 lbs.)
Dual RCA (female) to 3.5 mm (
/
") mini-plug (male) stereo adapter cable; dual RCA (female) to 3.5 mm (
1
8
mini-plug (female) stereo adapter cable; 45 RPM adapter
ATN3600L
/
")
1
8

Publicité

loading