Yamaha BD-S1900 Mode D'emploi page 20

DISC PLAYBACK
■ Loading the Batteries in the
Remote Control
1 Press the
part and slide the battery compartment
cover off.
2 Insert the two supplied batteries (AAA, R03, UM-4),
following the indications (+/–) on the inside of the
compartment.
3 Slide the cover back until it snaps into place.
Notes
– Do not subject the remote control unit to shock,
water or excessive humidity.
– The remote control unit may not function if the
Player's remote sensor is in direct sunlight or any
other strong light.
– Incorrect use of batteries may cause them to leak or
burst. Read the battery warnings and use the
batteries properly.
– Do not mix old and new batteries, or mix different
brands.
– Remove the batteries if you will not use the remote
control unit for an extended period of time.
Approximate operating range of
remote control
QUICK PURE DIRECT
16
En
Before Starting Playback
3
2
1
Remote control sensor
30˚ 30˚
6 m
OPEN/CLOSE DIMMER VIDEO-RESET
SUBTITLE AUDIO ANGLE
CLEAR ENTER
A B C D
TOP MENU/TITLE LIST POP UP MENU
ENTER
EXIT RETURN
SLOW/SKIP
STATUS
SEARCH
ON SCREEN
SETUP P in P REPEAT OFF
■ Turning the Power On
OPEN/CLOSE
SUBTITLE
QUICK PURE DIRECT
p
Turning the power on
Press p on the remote control or on the Player to turn on
the power of the Player.
P O W E R
Entering standby
Press p on the remote control or on the Player to enter
standby.
B Y E
Note
– If you press p again immediately after entering
standby, the Player may not turn on. If this happens,
wait for 10 seconds or more and then turn on the
power again.
■ Indicators on the front panel
display
indicator
BD Lights up when playing back a BD disc.
Lights up when playing back a DVD-
DVD
Video disc.
CD Lights up when playing back a CD.
Lights up when playing back.
Lights up when pausing.
Lights up when playing back a BD disc
TITLE
or DVD.
Lights up when playing back a BD disc,
CHP/TRK
DVD, or CD.
Lights up when playing back track or
REP S
chapter repeatedly.
DIMMER VIDEO-RESET
AUDIO ANGLE
O N
Descriptions