iGuzzini MWF9 Instructions page 4

Terminal block description
Symbol
Function
+VIN
power voltage input
-VIN
+10V
0/10V input
VSS
common-mode signal input
TXA
transmitter fot the device
syncronisation
TXB
T1 key 1
T2 key 2
T3
key 3 / Series syncronising
input
+CH1 (RA+) Red Anode
(RK-) Red Cathode
-CH1
+CH2
(GA+) Green Anode
(GK-) Green Cathode
-CH2
+CH3
(BA+) Blue Anode
-CH3
(BK-) Blue Cathode
Note
12V ( -VIN is internally connected to VSS)
device automatically identify the connected signals
Common bus for buttons, 0/10V signals
and syncronisation input
Connect to T3 of the next device
Connect to VSS of the next device
Device power, cycle selection and store of settings
Colour selection cycle white colour
turn/off
Selection of the cycle period
Max 6 LEDs for each channel @ 24V
4
Keyboard control
Key 1 :
Key 2 :
Key 3 :
0/10V input control
Range 10 / 1,2V : OFF
Range 1,2V / 9,8V : the colour cycle,
period from 15 seconds to 15 minutes;
Range 9,8V / 10V : stop the cycle on the
last colour shows.
Max 2 item M253-M829
Collegamento in serie per sincronizzazione
Only the first series device has a control input (in exemple 0/10V input,
but it can be keyboard or the remote control as well) other devices
syncronise to the first. Every device regenerates the syncronising signal,
so there is no theretical limit to the number of device that can be
connected.
ON/OFF, colour cycle, store of
the settings;
colour selection cycle;
selection of the cycle period.