iGuzzini MWF9 Instructions page 3

Operation with keys (not included)
Push key 1 (T1) to turn on/off the device; it starts from the last mode and setting stored.
Modalità colore fisso
Push key 2 (T2) to enable steady colour mode and set the desired colour: sequencer starts a colour variation cycle; a short flash
signals the cycle end. When the desired colour is on, push T1 to stop the cycle and store your settings.
Automatic colours variatin mode
Push key 3 (T3) to enable colours variation moe and set the desired cycle period. Each push of T3 lights a flashing colour, that matches
a time as shown in table 1.
For example, first push of T3 lights red which matches the 15 second cycle; push T3 again and it lights green, which matches the 30
second cycle, and so on. Once you have selected the required time, push T1 to store the settings; sequencr starts the colour variation
cycle with the desired period.
White light
If the device is in stand-by mode, push T2 to switch on the white light, and push it again to turn it off.
Operation with remote control
a four keys remote control manages the device in the same ways as the keyboard, except for the addition af another key, TR4. This key
controls whether white light is on or off.
Setting of the remote control code
The remote control is provided with a standard fctory code. For this reason we suggest to set a personalized code for the remote control
device. If you need to change this code, move dip switches, situated above the battery, from 1 to 7 (8 is not used). You have to make the
acquisition of the remote code in order to make the sequencer recognize the radio control (see following paragraph).
Remote control recognition
Before using the remote radio control, you need to save the remote control code into the sequencer, as described below:
* connect the sequencer outputs, power on the sequencer and let all outputs off;
* connect inputs T2, T3 and VSS on the sequencer for a while; (if you have connected a keyboard, press both key 2 and 3);
* the sequencer activates the outputs in a fast sequence; you can diconnect T2, T3 and Vss or release keys 2 and 3);
*in 10 seconds press any key on the radio control to complete recognition.
Operation with the 0/10V input
The minimum voltage to turn on the devices is Vin=1.2V. For input voltage in the ranfge 12V / 9.8 V the device does a cyclic variation of colours with a period directly related to Vin from
a minimum value of 15 seconds to maximum of 15 minutes. If the voltage input crosses the 9.8V threshold, the device stops the cycle in the last colour shows, and stores the setting.
Voltage inputs lower than 1.2V threshold turn off the device.
NB.: The remote control cannot be used in association with 0/10V input.
GB
3
Pressioni
Durata
Colore
T3 ciclo
lampeggiante
1 rosso
2 verde
3 blu 1 min
4 giallo 5 min
5 turchese 10 min
6 rosa 20 min
Tabella 1
code setting
dip switch
figura 1
battery
dip switch
Opening of the
radiocomando for
substitution batteries
and formulation code
battery
15 s
30 s