IMG STAGELINE TXS-892HSE Mode D'emploi page 7

5 Setting into Operation
1) Connect a headband microphone or a tie clip
microphone (e. g. the headband microphone HSE-
110 or the tie clip microphone ECM-402L from
"img Stage Line") to the mini XLR jack (3).
2) To switch on the transmitter, set the sliding switch
(2) to "ON".
The LED status indication (4) shows green to indi-
cate normal operation. If it shows red after switch ing
on or during operation, the inserted batteries are
almost exhausted and must be replaced.
3) Adjust the transmission channel: For this purpose
turn the rotary switch "CHANNEL" (5) by means of
the supplied small adjusting key in such a way that
the arrow points to the desired channel.
The 16 transmission channels are assigned to
the following transmission frequencies:
Channel Frequency
1 744.250 MHz
2 745.500 MHz
3 746.500 MHz
4 747.125 MHz
5 748.250 MHz
6 749.125 MHz
7 750.500 MHz
8 753.500 MHz
Note: If other wireless transmission systems are
operated with this wireless system at the same
time, the radio frequencies of the individual systems
should be carefully matched to each other to pre-
vent interference.
4) Switch on the receiver and set it to the same chan-
nel → see operating instructions of the receiver.
Switch on the audio unit (mixer or amplifier)
connected to the receiver.
5) Speak/sing into the microphone. The level of the
audio signal transmitted is indicated on the receiver.
The volume level can be readjusted by changing
the sensitivity via the gain control (6). For turning
the control use the supplied adjusting key. Adjust
the transmitter to the optimum level. If the level is
too high, the transmitter will distort, then turn back
the control (if necessary, turn it to the left stop). If
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
Channel Frequency
9 754.250 MHz
10 755.875 MHz
11 757.000 MHz
12 758.500 MHz
13 759.000 MHz
14 760.750 MHz
15 761.750 MHz
16 763.250 MHz
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
the level is too low, a poor signal-noise ratio will
result, then advance the control correspondingly.
6) After all adjustments have been made, put the
transmitter into the girdle bag again and secure it
with the velcro fastener against slipping out.
7) Fix the girdle bag with the velcro clip on its rear side
to your clothes.
8) To switch off the transmitter after operation, set the
sliding switch (2) to "OFF".
6 Specifications
Type of unit: . . . . . . . . PLL multifrequency pocket
Radio frequency
range: . . . . . . . . . . . . 740 – 764 MHz, divided into
Audio frequency
range: . . . . . . . . . . . . 40 – 18 000 Hz
Frequency stability: . . ±0.005 %
Transmitting power: . . 10 mW (EIRP)
Ambient temperature: 0 – 40 °C
Power supply: . . . . . . two 1.5 V batteries
Dimensions
(w/o bag): . . . . . . . . . 68 × 195 × 25 mm
Weight: . . . . . . . . . . . 130 g
Connection: . . . . . . . . mini XLR
1 = ground
1 3
2 = signal input
2
3 = operating voltage 5 V
for the microphone
Subject to technical change.
transmitter
16 channels
(→ table, chapter 5)
of size AA (R6)
GB
7