König Electronic SEC-DUMMYFL10 Mode D'emploi page 3

3. Place 3x AA 1.5 V batteries in the battery
compartment ,matching the polarity markings
(+ and -) to activate the flashing LED. Close the
housing and replace the screw after placing the
batteries.
Placing the batteries SEC-DUMMYFL20
1. Remove the screw marked in the image, using a
screwdriver.
2. Open the housing. Place 3x AA 1.5 V batteries in
the battery compartment, matching the polarity
markings (+ and -) to activate the flashing LED.
Close the housing and replace the screw after
placing the batteries.
Maintenance:
Clean the housing with a dry or damp cloth.
Do not use cleaning solvents or abrasives.
Warranty:
Any changes and/or modifications to the product will void the warranty. We cannot accept any liability
for damage caused by incorrect use of this product.
3