Parts Lists; Checking The Charge Level - Facom B124.1A Notice Originale

3/ PARTS LISTS

Voltage control button
Fuse
Voltmeter
Cable and positive clip +
Cable and negative clip -
12V selection socket 24V selection socket
Charging socket
Charging fuse
4/ CHARGING THE BOOSTER
Voltage selection socket 0V - 12V - 24V
The booster must always be left to charge when it is not being used.
Before charging your booster, make sure that the cables are wound separately on the booster unit identically to the photo in
the parts list.
All FACOM boosters must be charged in ventilated and dry premises.
Only use the FACOM 12V 4A B124.1A-CH charger to charge your BOOSTER.
Disconnect the 12V - 24V selection plug. Do not connect it during charging.
Check that the two 16A protections on the rear of the booster are activated. If they are not, press down on them firmly.
Connect the charger's 4-pin plug in the booster.
Connect the charger's power plug to the mains. The «POWER» light comes on green.
Press the charger's «START STOP» button.
- The light in the top left comes on yellow: the battery is charging.
- The light in the bottom left comes on green: the battery is charging.
- The light in the top right comes on red: internal booster problem. In this case, you must disconnect it and contact your
FACOM distributor.
- The light in the bottom right comes on red: the booster and the charger are not connected.
When the booster is charged you must leave it charging. The B12A.1A-CH is equipped with a «FLOATING» mode which keeps
the booster charged without the risk of damaging it.

5/ CHECKING THE CHARGE LEVEL

To check your booster's charge level, you must make sure that it is disconnected from its charger.
The 12V – 24V booster contains two 12V batteries. The voltmeter indicates the average voltage of the two batteries.
Press the charge check button.
For a full charge, the voltmeter must indicate 13V.
You must only use the booster if the needle is inside the yellow or green zones during the voltage test.
6/ USING THE BOOSTER
Before using the booster, you must check that:
- The vehicle is wedged, the transmission is in neutral and that the vehicle does not present any faults and is in good
6
mechanical condition.
booster NU-B124.1A_0417.indd 6 02/05/2017 09:12:39