Tips For Saving Energy - Burg BKG124A+ Guide D'utilisation

Réfrigérateur combiné encastré réfrigérateur - congélateur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The appliance performs poorly;
Check if;
• You have overloaded the appliance,
• The doors are not closed perfectly,
• There are not enough ventilation ducts on the kitchen unit as mentioned in the Installation
Manual.
If there is noise;
The cooling gas which circulates in the refrigerator circuit may make a slight noise (bubbling
sound) even when the compressor is not running. Do not worry, this is quite normal. If these
sounds are different check if;
• The appliance is installed firmly as described in the Installation Manual.
• The objects on the appliance are vibrating.
f there is water in the lower part of the refrigerator;
Check if;
The drain hole for defrost water is not clogged (use defrost drain plug to clean the drain hole).
Recommendations
• In order to increase space and improve the appearance, the "cooling section" of
refrigerators is positioned inside the back wall of the refrigerator compartment. When
the compressor is working, this wall is covered with frost or water drops. Do not worry.
This is quite normal. The appliance should be defrosted only if an excessively thick ice
layer forms on the back wall.
• If the appliance is not used for a long time (for example during the summer holidays), set
the thermostat knob to position " ". Defrost and clean the refrigerator leaving the door
open to prevent the formation of mildew and smell.

Tips For Saving Energy

1. Install the appliance in a coll, well vantilated room , but not in direct sunlight and not near
heat source (radiator, cooker.. etc). Otherwise use an insulating plate.
2. Allow ward food and drinks to cool down outside the appliance.
3. When thawing frozen food, place it in the refrigerator compartment. The low temperature
of the frozen food will help to cool the refrigerator compartment when it is thawing. So it
causes energy saving. If the frozen food is put out, it causes wastage of energy.
4. When placing, drinks and slops they must be covered. Otherwise humidity increases at
the appliance. Therefore the working time gets longer. Also covering drinks and slops
helps to save smell and taste.
5. When placing food and drinks, open the appliance door as briefly as possible.
6. Keep close the covers of any different temrepature compartment in the appliance (crisper,
chiller ...etc ).
7. Door gasket must be clean and pliable. Replace gaskets if worn.
EN -29-

Publicité

Table des Matières
loading

Table des Matières