Fichet-Bauche NECTRA Serie Mode D'emploi page 30

2. Using the lock
2.1 Power supply
The lock can be powered by :
- Batteries.
- External power supply (available as an option, for frequent use and time delay, please
contact your retailer).
2.2 Installing batteries
When the orange light flashes, batteries are flat and need to be replaced:
C Turn the keypad anticlockwise.
C Separate the keypad housing from the keypad.
C Insert and connect battery (use a 9 volts alkaline battery : 6LR61 type).
The lock will beep twice to confirm the connection.
C
Clip on the keypad housing carefully not to trap the electric cable, then turn the keypad
C
clockwise to close it.
C An alarm sound is emitted each time the lock is woken up (the lock wakes up by pressing a
key after at least 10 seconds of inactivity) until a complete opening session has been
carried out.
Codes, settings and blockings are stored and protected during power cuts.
Nectra
ELECTRONIC LOCK
30