Télécharger Imprimer la page

Audio-Technica AT-LP2D-USB Installation Et Utilisation page 8

Publicité

Les langues disponibles

Les langues disponibles

Tips For Better Performance
When opening or closing the turntable cover, handle it
gently, moving it either at the center or equally from
both sides.
Do not touch the stylus tip with your fingers; avoid
bumping the stylus on the turntable mat or a
record's edge.
Clean the stylus tip frequently, using a soft brush with
a back-to-front motion only.
If you use a stylus cleaning fluid, use it very
sparingly.
Wipe the dust cover and turntable housing gently with
a soft cloth. Use only a small amount of mild detergent
solution to clean the turntable and dust cover.
Never apply harsh chemicals or solvents to any part of
the turntable system.
Prior to moving the turntable, always unplug it from the
AC outlet and fasten the tone arm on the tone arm rest
with the vinyl twist-tie.
8
Specifications
Type
Platter
Motor
Speeds
Wow and flutter
Signal-to-noise ratio
Cartridge
Output level
Pre-amp "PHONO"
Pre-amp "LINE"
Power
Dimensions
Net weight
Furnished accessories
Replacement stylus
Belt drive turntable, fully automatic
Aluminum
DC servo-controlled
33
1
/
RPM, 45 RPM
3
Less than 0.25% (WTD) @ 3K Hz (JIS)
50 dB
Integral Dual Magnet
stereo cartridge
with diamond stylus
2.5 mV nominal at 1 KHz, 5 cm/sec
200 mV nominal at 1 KHz, 5 cm/sec
120V AC, 60 Hz, 3W
14.17" (360 mm) W x 3.82" (97 mm) H x
14.06" (357 mm) D
6.6 lbs. (3 kg)
Dual RCA (female) to
1
/
" (3.5 mm) mini-
8
plug (male) stereo adapter cable; dual
RCA (female) to
1
/
" (3.5 mm) mini-plug
8
(female) stereo adapter cable; USB cable;
45 RPM adapter
ATN3600L

Publicité

loading