Télécharger Imprimer la page

Warm Tech WTCAC50R Traduction Des Instructions D'origine page 46

Publicité

Les langues disponibles

Les langues disponibles

5. INSTALLATION INSTRUCTIONS
Only install the heater in normal upright position.
Do not place the heater near walls, corners or low ceilings.
Do not place the heater below a socket outlet.
Do not place the heater on moving vehicles or where it can tip over.
Keep the heater away from flammable, combustible, explosive or corrosive materials.
Keep the heater away from curtains or similar materials that could block the air inlet
and outlet.
Never block or restrict the air inlet and outlet for any reason.
Keep the power cable away from heat sources, sharp edges, cutting and moving parts.
Do not expose directly to the weather or to excessive humidity.
Do not place the heater in the immediate surroundings of a bath, shower or swimming
pool.
Floors and ceilings must be made of fireproof materials in the place where the heater is
operated.
Do not connect direct-fired heaters to air ducts.
Preparation before the operation
1、 Never use high volatile fuel such as gasoline etc;
2、 Only fill the fuel tank when the heater stops running and the flame goes out;
3、 Please use No JIS1 kerosene or frostbite-prevent light diesel,never use degenerative, impure
kerosene or diesel;
4、 When you fill the fuel tank, the tank filter must be installed;
5、 When kerosene or diesel touches human body please wash with soap immediately, to prevent
potential skin inflammation;
6、 The burner surface is very hot just after flameout, so never touch it with hand or let oil pump come
in touch with the burner, to prevent scalding or some other injure.
When there is no fuel (kerosene or diesel) in the tank:
How to fill the tank:
1、Make sure the power plug is removed from the power source and the power switch is in OFF
position"0";
2、Place the appliance on a stable and level ground, remove the fuel cap and fill the fuel tank with fuel
filter installed. Do not overfill your heater, see the full level position as shown in under figure;
3、Check if there is water or waste in the fuel tank, clean the tank if it is dirty;
4、Fill kerosene or diesel in fuel tank with oil pump only when the fuel filter is proper installed, after the
filling turn the cap clockwise and tighten it.
46

Publicité

loading