Warm Tech WTCAC50R Traduction Des Instructions D'origine page 45

4. ASSEMBLING INSTRUCTIONS
A．Hot air outlet
B. upper shell
C.rear handle
D. front handle
E.cord wrap
F.lower shell
G.fuel gauge
H.fuel cap
I．wheel
J. Side cover
K.digital temperature display
L.thermostat knob
M.Power switch
N.lower tube frame
O. Fuel tank
P.power cord
Q.Pressure gauge
R.Pressure gauge
Assembling wheels and tube frame
1、insert the wheel axle to the corresponding hole of lower
tube frame，set bushing G at the two ends，slide the
wheel F over the wheel axle H，put on wheel cap E。
2、Put the heater body on the lower tube frame B, make sure
the 4 holes of handle frame point towards the
corresponding 4 holes on the lower tube frame
respectively.
3、Insert screws J in the holes，place flat washers D under
the lower frame B and tighten the hexangular screw C。
4、Insert other screws in the holes respectively and use a
screw driver to tighten them by the same way.
45