Adler europe AD 2321 Mode D'emploi page 4

immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified electrician
before using it again.
18. Do not touch the device or power adaptor with wet hands.
19. The device has to be turned off after every use.
20. Do not leave the unit on to the wall outlet or power supply unit unattended.
21. If the device utilises a power adaptor, do not cover it, because this can cause a
dangerous temperature rise and can damage the device. Always connect the power adaptor
cable to the device, and then connect the power adaptor to the power socket.
22. Keep the device out of the reach of children. Using the devices by children must be
supervised by adults.
23. The power cord should not touch hot parts of the device and should not be located near
other heat sources.
24. Do not wrap electric cable around the device.
25. Do not use the appliance in the bath.
26. Do not remove dust or foreign bodies from the inside of the hair straightener using sharp
objects.
27. Do not use outdoors or where aerosols are being used or where oxygen is being
administered.
28. Do not cover the appliance, it might cause the accumulation of heat in its interior and it
may cause damage or fire.
29. Hairsprays contain flammable materials. Do not apply them while using the device.
30. Do not use the device on people who are sleeping.
31. The device can be supplied only with the voltage specified on the housing.
32. During operation, do not place the device on wet surfaces or clothes.
33. After use, turn off and unplug the unit. Wait until the device cools down before storing.
34.During the operation ceramic plates heat up to high temperatures. Do not touch hot parts
of the hair curling iron and do not allow contact with the skin of the head, because it may
cause burns.
35. The device is not designed to work with external schedulers or separate remote control
system.
DESCRIPTION OF THE DEVICE
1. Display
4. On/Off and temperature adjustment switch
USING THE DEVICE
To achieve the best results in hair straightening, use device on washed, brushed and dry hair.
1. Before starting the device, the electrical wire should be fully unrolled.
2. Insert the plug into the socket. Device will show "OFF" sign on display (1).
3. Turn on the hair straightener by pressing and holding switch (4) for 3 seconds. LED display (1) will show temperature. Press switch to
set up desired temperature (4) 140°C, 160°C, 180°C, 200°C, 220°C.
NOTE: Use lower temperatures for fine, bleached or damaged hair, medium temperatures for normal hair, and higher temperatures for
thick hair.
4. Wait 3-5 minutes to allow the appliance to reach its working temperature. Sign will stop flashing once it reaches desired temperature.
5. Starting from the top of the head choose a small strand of hair, straighten it and comb.
6. Then put it between the plates (3).
7. Move slowly in the direction from the roots to the tips of hair.
NOTE: The unit is hot during operation. Avoid touching your hands or scalp with the hot plates.
8. Repeat points 5-7 until all the hair strands will be stretched.
9. Once you finish, press switch for 3 seconds to turn the hair straightener off. Device will show "OFF" sign on the display (1). Then unplug
the power cord from the outlet. Let it cool down before it is stored.
NOTE: This appliance can be used on natural hair wigs. Do not use it on artificial hair wigs and hair strands as these may melt in the heat
2. Handle 3. Floating plates
5. Swivel cord with hanging hook.
4