lawnmower or its charging base.
j) Do not allow robotic lawnmower to be used
with a defective blade disc or body. Neither
should it be used with defective blades,
screws, nuts or cables.
k) Always switch off robotic lawnmower when
you do not intend to use the mower. Robotic
lawnmower can only start when the power
is on and the correct PIN code has been
entered.
l) Keep your hands and feet away from the
rotating blades. Never place your hands or
feet close to or under the body when robotic
lawnmower is in operation.
m) To avoid using the machine and its
peripherals in bad weather conditions
especially when there is a risk of lightning.
n) Not to touch moving hazardous parts before
these have come to a complete stop.
o) For machines used in public areas, warning
signs shall be placed around the working
area of the machine. They shall show the
substance of the following text:
Warning! Automatic lawnmower! Keep away
from the machine! Supervise children!
2. Additionally when the appliance is
operating automatically
a) Do not leave the machine to operate
unattended if you know that there are pets,
children or people in the vicinity.
Maintenance and storage
WARNING! When the mower is turned
upside down the power must always
be off.
The power should be off during all work on
the mower's under frame, such as cleaning
or replacing the blades.
a) Keep all nuts, bolts and screws tight to
be sure the appliance is in safe working
condition.
b) Inspect the robotic lawnmower each week
and replace worn or damaged parts for
safety.
c) Check especially that the blades and blade
disc are not damaged. Replace all blades and
screws at the same time if necessary so that
the rotating parts are balanced.
d) Ensure that only replacement cutting means
of the right type are used.
e) Ensure that batteries are charged using
the correct charger recommended by the
manufacturer. Incorrect use may result in
electric shock, overheating or leakage of
corrosive liquid from the battery.
f) In the event of leakage of electrolyte flush with
water/neutralizing agent, seek medical help if
it comes into contact with the eyes etc.
g) Servicing of the appliance should be
according to manufacturers' instructions.
Recommendation
To connect the machine and/or its peripherals
only to a supply circuit protected by a residual
current device (RCD) with a tripping current of
not more than 30 mA.
Residual risks
To avoid injuries, wear protective gloves when
replacing the blades.
Transport
The original packaging should be used when
transporting robotic lawnmower over long
distances.
To safely move form or within the working area:
a) Press the STOP button to stop the mower.
You select the four digit PIN code when you
start the mower for the first time.
b) Always switch off robotic lawnmower if you
intend to carry the mower.
c) Carry the mower by the handle at the rear
under the mower. Carry the mower with the
blade disc away from the body.
RF exposure requirements
To satisfy RF exposure requirements, a
separation distance of 200mm or more should
be maintained between this device and persons
during device operation.
To ensure compliance, operatons at closer than
this distance is not recommended. The antenna
used for this transmitter must not be co-located
in conjunction with any other antenna or
transmitter.
This is a class III appliances and it must
only be supplied at safety extra low voltage
corresponding to the marking on the appliance.
Safety Warnings for battery pack inside the
tool
a) Do not dismantle, open or shred battery
pack.
b) Do not short-circuit a battery pack. Do
not store battery packs haphazardly in
a box or drawer where they may short-
circuit each other or be short-circuited
by conductive materials. When battery
5
EN