KRESS Mission KR236E Manuel Du Propriétaire page 13

screwdriver and remove the blades.
6. Firmly screw on the new blades and new screws for fixing blades.
7. Refit and firmly screw on the disks on the underside of Mission
8. Refit the battery and the battery cover.
Important: After screwing the blade to the blade disc, make sure the blade is able to spin freely.
2
Keep it Clean
WARNING: Before cleaning, turn your Mission
cleaning the blade turning disc and do not rinse or flush with water.
WARNING! YOUR Mission
pressure washer on your Mission
damage electronic and mechanical parts.
A. Cleaning the Body
Your Mission RTK will live a much happier and longer life if it is cleaned regularly. Since your Mission
TM n
is an electric machine, you will need to take care when cleaning. Hose water clean is supported. It is best to
use a spray bottle filled with water. When cleaning the machine body, use a soft brush or clean cloth and avoid
using solvents or polishes. Lastly, remove all build up of grass clippings and debris.
B. Cleaning the underside
Again, it is important that you power the Mission
OFF and wear protective gloves before
RTK
n
touching the blade turning disc. First, flip
your Mission RTK upside down to expose its
TM n
underside. Here you will see the blade disc, the
chassis, and the front wheel and driving wheels.
Clean everything thoroughly with a soft brush or
moist rag. Hose water clean is supported.
Rotate the blade disc to ensure it rotates freely.
Check the blades spin freely around the fixing
screws. Remove any obstructions.
IMPORTANT: Remove any stuck debris so
that it does not cause a crack in the blade
disc. Even the tiniest crack can decrease your
Mission RTK 's mowing output.
TM n
C. Clean the contact pins and the charging strips
Clean the contact pins located on the charging
base and the charging strips located on the
Mission RTK using a cloth. Remove any built
TM n
up grass clippings or debris around the contact
pins and charge strips periodically to ensure the
Mission RTK successfully charges each time.
TM n
TM
RTK can only be washed by using a hose! DO NOT use high
TM n
RTK . High pressure water can go inside the sealings and
TM n
TM
RTK .
TM n
RTK OFF. Put on protective gloves before
n
RTK
TM n
13
EN