Interior Finish; Poser Le Liner Diagonalement Au Profil Hung - VALCKE ExteriorLiving Octoo 400 Notice De Montage

montage-anleitung

2.3 Interior finish

1
Mark the opening of the return (2x) and
remove the piece with a drill .
Liner overhoeks in
het hungprofiel plaatsen
If you want to include an underwater light, you must first drill the hole (25 mm dia .) for the connector to guide the cable out of the pool .
Determine the position, preferably 70 cm (28 in) below the border edge, and in the middle of a plank .
4
1
Poser le liner diagonalement
au profil hung
In order to attach the lining, the hung-profile
4
is screwed to the inside of the pool at 20cm
intervals . (stainless steel screws 4x30mm)
Ensure walls are dust-free to avoid irregu-
larities in the liner .
1
Put the liner diagonally
in the hung-profile
4
The position of the liner needs to be
100% correct and the liner should have
min . 18°C so that there is sufficient
elasticity . An opening must be cut for the
skimmer and the water return device .
tIp: Store the liner some days in advance
at room temperature .
70
3
Stick the seal on the wall and push the
return (2x) through the opening . On the
outside, tighten the return until it is secu-
rely in place .
2
3
Glue the fleece in place under the hung
2
profile and glue onto the walls .
3
2
You can tape the corners of the pool in
order to prevent folds in the liner . Unfold
the liner in such a way that the corners
of the liner correspond with the corners
of the pool .
The pool can now be filled with a few inches of tap water . On bare feet and using a
plastic squeegee, remove the folds in the liner and press the liner well into the cor-
ners of the pool . Before making the incision into the liner for the skimmer hole, fill the
pool to a few inches below the position of the water return opening . Please follow the
illustrations included in the skimmer and water return's packaging . During the filling of
the swimming pool the wood structure on the outside should be filled in gradually .
Now you must place the coupling and
connect it to the tap via a hose (see
technical section: 2 .4 .3 Connections) so
that the bath can be further filled .
Press the felt nicely for an even attach-
ment .
Slide the edge of the liner into the Hung-
profiles, ensuring that the corners of the
liner match up well below .