Accessories; Summer Tarpaulin; Winter Tarpaulin; Technical Housing - VALCKE ExteriorLiving Octoo 400 Notice De Montage

3. accessories

3.1 Summer tarpaulin

A summer tarpaulin can be placed across
the pool . Sunrays can increase the water
temperature . The tarpaulin is simply
placed on the water; when using the
pool the tarpaulin is removed and turned
over to dry . It is best to roll the tarpaulin
up to prevent tears . The tarpaulin should
not be walked upon .
_____

3.2 Winter tarpaulin

During the winter months when the
pool isn't in use, a winter tarpaulin can
be placed across the pool . Distribute the
hooks equally around the outside of the
pool . Screw them on the sides of the
pool and fix the tarpaulin to the attached
hooks with the rapid binders .
This tarpaulin should also be rolled when
not used, to prevent tears . The winter
tarpaulin should not be walked upon .
_____

3.3 Technical housing

A technical housing can either be built in,
or loose standing . The built-in technical
housing is attached to the side of the
pool where the skimmer and water
return device are situated . The filter unit
is also placed inside this . (See 4 Safety)
Follow the instructions in the enclosed
drawing .
Screw one side to the pool, and as-
semble a few planks to the front to get
a perfectly angled structure . Then screw
on the other sides . This built-in technical
housing is available in three different
dimensions .
The loose standing model with 4 sides
is built up in a similar way .
_____

3.4 Electrical box

Follow the instructions in the enclosed
manual .
The electrical box is suitable for the elec-
trical connection of the pump and max .
3 underwater lamps . The box is provided
with a highly sensitive differential and
a transformer for the underwater lamp .
You can program the working of the
pump with the built-in timer .
The installation should be done by an
electrician . The local legislations and
applicable regulations must be respec-
ted . The waterproof IP65 box may be
placed at less than 3 .5m from the pool .
The power supply to the electrical board
must be secured upstream by a high
sensitivity differential . (max 30 mA)
_____
ENGLISH
59