VALCKE ExteriorLiving Octoo 400 Notice De Montage page 58

manual
Stainless steel steps
The stainless steel interior steps are
assembled according to the instructions
and are attached on top of the border .
not suitable in salted water !
1) Define the place of the steps holders
80 mm from the inside of the coping .
2) Bore out two holes for the holders
with a brace diameter 50 mm .
1
ø50 mm
2
3
58
3) Place the two holders and screw
them with the screws which were also
supplied .
4) Place the rubber pieces at each end
of the stainless steel steps, for the
protection of the liner .
80 mm
4
ground
5) Place the metal covering plates over
the holders and install the steps .
6) Place the supporting plank and screw
it (see assembly 2 .2 .2 .) .
5
6