Danby DBC057A1BSS Manuel Du Propriétaire page 9

CARE & MAINTENANCE
CLEANING
Ensure the appliance is unplugged before cleaning.
• To clean the inside of the appliance, use a soft
cloth and a solution of a tablespoon of baking
soda to one quart of water or a mild soap
solution or some mild detergent.
• Wash removable shelves in a mild detergent
solution, then dry and wipe with a soft cloth.
• Clean the outside with a soft, damp cloth and
some mild detergent.
• It is important to keep the area clean where the
door seals against the cabinet. Clean this area
with a soapy cloth. Rinse with a damp cloth and
let dry.
Note: Do not use cleaners containing ammonia or
alcohol on the appliance. Ammonia or alcohol can
damage the appearance of the appliance. Never
use any commercial or abrasive cleaners or sharp
objects on any part of the appliance.
VACATION
• Short vacations: Leave the appliance operating
during vacations of less than three weeks.
• Long vacations: If the appliance will not be used
for several months, remove all items and turn
off the appliance. Clean and dry the interior
thoroughly. To prevent odor and mold growth,
leave the door open slightly, blocking it open if
necessary.
DISPOSAL
This appliance may not be treated as regular
household waste, it should be taken to the
appropriate waste collection point for recycling
of electrical components. For information on local
waste collection points, contact your local waste
removal agency or government offi ce.
TROUBLESHOOTING
FREQUENTLY ASKED QUESTIONS
No power
• A fuse may be blown or the circuit breaker
tripped
• Plug not fully inserted into the wall outlet
Internal temperature not cold enough or the
appliance is running continuously
• Door is not shut properly or opened excessively
• Exhaust vent is obstructed
• Recently added a large quantity of warm bottles
to the cabinet
• Close proximity to heat source or direct sunlight
• Ambient temperature or humidity is very high
• Possible system leak, evaporator fan failure or
compressor failure
Condensation on the cabinet or door
• Door is not shut properly or opened excessively
• Ambient temperature or humidity is very high
ERROR CODES
CO: control system communication fault
E1: interior sensor fault
E2: defrost sensor fault
dr: door is open for more than 1 minute
EH: internal temperature is 8 degrees higher than
the set temperature for more than 30 minutes
EL: internal temperature is 8 degrees lower than the
set temperature for more than 30 minutes
Lc: the control panel is locked
If error codes appear on the display for more than
5 minutes, a power reset may rectify the issue.
Unplug the appliance, wait 5 minutes and then plug
the appliance back in. If the error code persists
after a power reset, contact consumer care or an
authorized service agent.
In the case of the "Lc" error code, the control panel
is locked. Press and hold the lock button for 3 sec-
ond to unlock the control panel.
8