Publicité
Les langues disponibles
Les langues disponibles
4.2.1
INFRARED REMOTE SETUP
You can use your favorite infrared remote control with the TV Transmitter. The TV Trans-
mitter has an intelligent learning ability to recognize and save new IR remotes.
Using your TV's infrared (IR) remote control, you can increase, decrease, or mute the vol-
ume through the Levven Audio TV Transmitter.
Follow these instructions to setup this feature:
a) Prepare by having your favorite infrared remote control near at hand.
b) Power off the TV Transmitter by removing the USB plug from the TV's USB port, or
from the supplied USB power adapter.
c) Remove the optical or coax audio input cable from the TV Transmitter's 3.5mm jack.
The IR learning is initiated when the TV Transmitter is powered on without the audio
cable.
d) Power on the TV Transmitter. Insert the TV Transmitter's USB plug into the TV's USB
port, or the supplied USB power adapter.
e) The TV Transmitter's LED will flash twice when powered up to indicate learning has
started.
f) Point your remote to the front of the TV Transmitter and press and release the follow-
ing remote-control buttons in order:
g) After each press and release, the TV Transmitter's LED will briefly flash.
h) After pressing mute on your remote control, the TV Transmitter's LED will stay on solid
for 2 seconds, confirming that the learning process was completed successfully.
i)
Reconnect the optical or coax audio cable to the TV Transmitter's 3.5mm audio input
jack.
j)
Power cycle the TV Transmitter by removing the USB plug and plugging it back in.
k) Enjoy using your remote to control the TV Transmitter's volume.
NOTE: If you make a mistake in learning the buttons on your remote, restart the process
and perform the steps again.
4.3
SETUP WITH AUDIO NOT FROM A TV
You may prefer to setup Soul Sub when your audio comes not from your TV, but from your disc
player, your cable box, your set top box (Amazon Fire TV
lite box.
You can follow the same procedure as described in the previous section, but instead connect
your TV transmitter to your preferred audio source.
4.4
PHONE OR TABLET DEVICE SETUP
Soul Sub can also play audio from any SKAA transmitter.
1.
Insert a SKAA transmitter into your device.
2. Play some audio on your device.
3. Double-click the SKAA Bond button on Soul Sub. The SKAA Bond LED will be lit bright amber
and you will hear your audio playing on Soul Sub.
4. Press and hold the SKAA Bond button for 3 seconds to add your SKAA transmitter to Soul
Sub's green list. The SKAA Bond LED will be lit bright green.
Transmitter to the Soul Sub's green list. The SKAA Bond LED will turn bright
green.
iv. Press Soul Sub's bond button four times to put Soul Sub into swing mode. The
SKAA Bond LED will turn bright red.
i.
Volume Up
ii. Volume Down
iii. Mute
, Roku
or Apple TV
TM
TM
), or your satel-
TM
7
Publicité
