Whirlpool GU3200XTPS5 Instructions D'installation page 15

4. Reinstall thescrews t hrough theholies i ntheaccess
paneH a ndtheshots i ntheHower panelInstall r ightside
screw first,
J
J
J
5. Check that the lower edge of the lower paneH contacts
the floon
6. Tighten the screws,
Direct wire method:
Electricam Shock Hazard
Emectricatmy ground dishwasher.
Connect ground wire to green ground connector in
terminam box.
Do not use an extension cord,
Failure to follow these instructions can resumt in death,
fire, or electdcam shock.
Power supply cord method:
Electrical Shock Hazard
Plug into a grounded 3 prong outmet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Faimure to follow these instructions can result in death,
fire, or emectrical shock,
7. Reconnect power or plug in dishwasher,
Check operation
1,
2.
3.
4.
5,
6,
Read the Use and Care Guide that came with your
dishwasher,
Check that all parts have been installed and no steps
were skipped.
Check that you have all the tools you used.
Start dishwasher and allow it to complete the shortest
wash cycle. After the first two minutes, unlatch door,
wait five seconds, then open doon
Check to see that there is water in the bottom of the
dishwasher tub. Check that dishwasher is working
properly.
If not, disconnect power or unplug dishwasher and see
"If dishwasher does not operate" section.
mfdishwasher does not operate
First try the solutions suggested here to possibly avoid the
cost of a service call,
+ Has the circuit breaker tripped or the house fuse blown?
+ ts the door closed tightly and latched7
+ Has the cycle been set correctly to start the dishwasher?
+ Is the water turned on?
If none of these work, call 1-B00-253+1301,
or in Canada, call 1-800+807-6777.
15